XTORSION® Copper

Mid Launch and Low Spin
MSRP
$350.00USD

The ALDILA® XTORSION® Copper features a stiff tipped, Counter Balanced design along with a new and unique woven graphite material on the outer layer of the shaft at the tip-section. This Multi-Axial Material Bias Angle (MAMBA®) Technology places a high-tech material on the shaft in a +/- 45 degree fiber orientation. This unique use of a flat weave material on the exterior of the shaft provides significantly improved torsional stability to this counter weighted shaft in the lower half (tip-section) where the greatest percentage of twisting occurs during the swing and at impact.

  • Specifications

    ITEM DESCRIPTION

    FLEX

    LENGTH(in)

    WEIGHT(g)

    TIP O.D.(in)

    TIP LENGTH(in)

    BUTT O.D.(in)

    TORQUE(degrees)

    KICK PT.

    TIP TYPE

    XTORSION™ Copper 50

    R

    46.0

    56

    0.335

    3.0

    0.610

    4.8

    MID/HIGH

    PARALLEL

    XTORSION™ Copper 60

    S

    46.0

    67

    0.335

    3.0

    0.610

    4.2

    MID/HIGH

    PARALLEL

    XTORSION™ Copper 70

    X

    46.0

    70

    0.335

    3.0

    0.615

    3.3

    MID/HIGH

    PARALLEL

    XTORSION™ Copper 70

    TX

    46.0

    70

    0.335

    3.0

    0.615

    2.9

    MID/HIGH

    PARALLEL

  • Technology

    High Balance Point

    By using innovative materials and creating slightly thicker walls toward the butt-end of the shaft we raised the balance point of the shaft which creates the potential for lighter swing weights, increased head-speed and distance.

    Multi-Axial Material Bias Angle (MAMBA®) Technology

    Multi-Axial Material Bias Angle (MAMBA®) Technology places a high-tech, flat weave material on the shaft’s lower half exterior, where the most twisting occurs during the swing and at impact. MAMBA® Technology improves torsional stability and spin control where it’s needed the most.

  • Fitting

    Driver Speed (mph)/Driver Carry (yds)

    80/210

    81-90/210-239

    92-105/240-259

    106+/260+

    XTORSION® Copper 50

    R

    XTORSION® Copper 60

    S

    XTORSION® Copper 70

    X/TX

  • Tip Trimming Information

    Trim Code

    Procedure

    A

    Trim to length from butt end.

    B

    Tip Trim in 1/2" increments (3-PW).

    C

    Tip Trim in 1/2" increments (3W-7W).

    D

    Tip Trim Driver 2", 3W 2-1/2", 4W 3", 5W-7W 3-1/2".

    E

    Tip Trim 2", then 1/2" increments (3-PW).

    F

    No Tip Trim for Driver. Trim to length from butt end. Tip Trim Fairway Woods 1", then to length from butt end. For hosel designs with bore thru depths greater than 2", we recommend blind boring the shaft in the hosel 1-3/4".

  • Media